For germinating seeds, use a sterile, fine, soilless seed-starting mix. It holds moisture, drains well and has little or no nutrient load, which suits young seedlings. Garden soil is usually too heavy, and it can carry pathogens and weed seeds. Potting mix can work in a pinch, but it is more likely to stay wet and it contains more nutrients and organic matter than seeds need.
Short answer
Choose a seed-starting mix made from peat or coir with perlite or vermiculite. Buy one labeled for seed starting, look for OMRI listing if you garden organically, and check that it is labeled for soil blocks if you plan to use blocks. Avoid garden soil.
Seed-starting mix, potting mix or garden soil?
Seed-starting mix is fine-textured and designed for germination. Seeds and very young roots can push through it easily, and it holds moisture without becoming waterlogged. It is usually sterile, which lowers the risk of damping off.
Potting mix is coarser and contains more organic matter and nutrients. It holds more water than seed mix and is more likely to stay wet around tiny seeds. It is a better choice for potting up seedlings than for sowing.
Garden soil is heavy and dense. It can crust over, block seedlings, and carry soil-borne disease and weed seeds. It is not a good medium for seed starting, even if it looks rich.
Is seed-starting mix necessary?
It is not strictly necessary, but it is usually the easiest route to good germination. Many gardeners start seeds in potting mix and do fine, but they need to be more careful about watering. If you use garden soil, you will likely see more failures, slower sprouting and more damping off.
The main reasons to use a dedicated seed mix are its texture, its sterility and its low nutrient level. Young seedlings do not need much feed from the medium in their first weeks. They need moisture, air and a clean environment.
What goes into a good seed-starting mix
Most seed-starting mixes are built around a few components:
- Peat or coir. These hold water well. Peat is common but has sustainability concerns. Coir is a popular alternative. Peat also repels water when it dries out, so it needs thorough moistening before use.
- Perlite. This volcanic glass is heated until it expands. It adds air space and drainage.
- Vermiculite. This mineral holds moisture and is often used to cover seeds. Some vermiculite has been linked to asbestos contamination, so many growers choose perlite instead. If you use vermiculite, buy from a reputable supplier and wash your hands after handling it.
- Fertilizer. Many mixes contain a small amount of slow-release feed. Some do not. A low amount is usually fine for the first few weeks.
- Wetting agent. Some mixes include one to help peat absorb water. It is helpful, especially if you need to re-wet a dry bag.
Look for OMRI listing if you prefer organic inputs. The listing shows that the product is allowed in organic production.
Mixes compared in one trial
One grower tested four OMRI-listed organic mixes side by side. In pots, Burpee’s mix sprouted fastest and produced the most vigorous seedlings, with no damping off. Promix was close behind and held together best when used in a soil blocker. Sprout Island came third, and Black Gold was the weakest of the four, with one seed failing to sprout and less vigorous seedlings.
This was one person’s trial, with small numbers, not a laboratory study. Use it as a guide, not a ranking. Try a bag of mix yourself, sow a tray, and compare the results in your own conditions.
Soil blocks need a different mix
If you make soil blocks, the mix must hold its shape when pressed. Many seed mixes crumble when used in a blocker. Look for a mix labeled for blocks, or test any mix with a squeeze before you press a full tray. For more on soil blocks, see soil blocking seed starting mix.
Making your own mix
Some gardeners make their own seed mix from peat or coir, compost, perlite and a little lime or fertilizer. Recipes vary widely, and the results depend on the ingredients. For many gardeners, a good commercial mix is simpler and more consistent than sourcing and blending ingredients, especially for small batches. Homemade mix is more worthwhile if you start a large number of seeds every year and can control the quality of each ingredient.
If you make your own, be consistent. Sieve the compost to remove large pieces, moisten the whole batch thoroughly, and test a tray before sowing a full set.
Sterility, reuse and storage
Sterile mix helps keep damping off and insects away. Once a bag is opened, keep it dry and sealed. Damp mix can grow mold and attract pests. Old mix that has held seedlings can carry disease, so discard it or clean the containers before reuse. If you are unsure whether old mix is safe, use a fresh bag for seeds.
For the containers that hold your mix, see the best container to start seeds in.
Frequently asked questions
Which soil is best for seed germination? A sterile, fine seed-starting mix made from peat or coir with perlite. It is designed for moisture, air and low nutrient levels.
Can I use potting soil? You can, but it holds more water and nutrients, so it is more likely to stay too wet. Use it with care, and check moisture often.
Can I start seeds in perlite alone? Not well. Perlite holds air and drains freely, but it does not hold enough moisture or nutrients for most seedlings in the long run. It works best as a component of a mix.
Is seed-starting mix the same as seed-starting soil? People use both terms. Seed-starting mix is usually soilless, so the name refers to the product rather than to soil in the garden sense.
Keep going
- Start seeds indoors with the full process.
- Try soil blocks if you want a mix that holds its own shape.
- Start seeds in rockwool, plugs or LECA for a soilless alternative.